How To Solve Common Problems With OEM Scoopy Motorcycle?

Dec. 14, 2018

Fault 1: When the motor of the OEM Scoopy Motorcycle is turned, it stops.

The reason and solution are:

(1) The battery is low, and the battery should be charged to make it fully charged.

(2) The battery contacts are in poor contact. At this time, the contact position should be adjusted or the contacts should be polished.

(3) There is a problem in the controller. At this time, the controller should be repaired. If not, replace the controller.

(4) The speed control handle leads are disconnected, and the lead should be replaced at this time.

(5) The inner connector of the line is soldered, and the plug should be re-plugged so that the contact can be good.

Fault 2: After the battery is charged, the bicycle travel is not enough.

The reason and solution are:

(1) The battery has deteriorated, and the battery should be replaced from Motor Tricycle OEM Manufacturer at this time.

(2) A short circuit occurs in the motor part, causing the current to be too large. At this time, the motor should be replaced.

(3) The controller is damaged and the controller should be replaced at this time.

(4) The charger output voltage is low, and the charger should be replaced at this time.

Fault 3: The speed of the moped can't work.

The reason and solution are:

(1) The mechanical fault is not flexible, and should be repaired at this time

(2) The speed control handle is damaged. At this time, the speed control handle should be replaced.

(3) There is a problem with the motor or controller and should be replaced at this time.

OEM Scoopy Motorcycle

  • Mob.: +86 139 2991 7173
  • E-mail: godwinchen@hulonmotorcycle.com
  • Tel. / Fax.: +86 757 2836 8813
  • Add.: NO.15 factory, Tangxia Town, Pengjiang District, Jiangmen, Guangdong province, PR China
  • Postcode: 528000
Follow Us
Hualong Motorcycle Co.,Ltd.

Copyright © Hualong Motorcycle Co.,Ltd. All Rights Reserved.